Responding to Instructions to LOAD Media, HP4000

Instructions to load the media requested in TRAYs 1,2 or 3 must be followed - the printer has run out of paper!!

This printer is configurable to print special media by folding down both the multi-purpose media tray (input, TRAY 1) and the rear output tray. It is imperative that a straight-through paper path is used for any special media. If the message displayed on the panel requests:

If the media request on the panel is NOT one listed above, then we regard the request as spurious and press either the green GO button to print the job on plain A4 paper, or the red job cancel button to discard the job.

1. Fold down REAR output tray[*]
2. Fold down Tray 1.
3. Load the requested media face up, top edge innermost.
4. The job will automatically start to print - don't press any buttons!!
5. ... Don't go away!! ...

        MANUALLY FEED
        END    A4

1. REMOVE the output and CLOSE the rear output tray.
2. UNLOAD any unused media and CLOSE TRAY 1[*].
3. Now, and only now, please press the green GO button to indicate that the normal printer configuration has been restored. A piece of plain paper is then printed.
4. NB Under no circumstances should special media be left loaded in the printer after the job has finished.

Thank You.

For further information, see: man prlabel.

• It is imperative that a straight-through paper path is used for any special media.
• Under no circumstances should special media be left loaded in the printer after the job has finished.
  

Revision Date: 28th August 2000